Morpheus8
JUNISH Cosmetic Clinic1/11 Windsor Avenue, Mount Waverley Victoria 3149Show on map
Morpheus8 Microneedling with Radiofrequency energy to deliver controlled treatment into the skin. This may help stimulate the skin’s natural renewal processes and support improvements in the appearance of fine lines, skin texture, uneven tone, acne scarring and mild skin laxity, depending on your individual treatment plan.
Learn more about Morpheus8 here.
Acne ScaringMicroneedling RFRadiofrequencySkin LaxitySkin Tightening
Treatment Information
- Treatment Type
- Radiofrequency (RF) Microneedling
- Results
- 1–2 weeks, with optimal results in 6–12 weeks
- Longevity of Effect
- 9 months, 12 months
- Number of Sessions
- 2–3 sessions recommended
- Interval Between Sessions
- 4 to 6 weeks between sessions
- Downtime
- 1 to 3 days
- Possible Reactions
- * Temporary redness (erythema) and mild swelling (edema), which typically subside within 1–3 days. * Micro-crusting or tiny scabs appearing 24–72 hours post-treatment; these will naturally flake off within a week. * Mild tenderness, warmth, or a sunburnt sensation in the treated area. * Occasional minor bruising or pinprick marks from the microneedles.
- Pain Level
- Some pain depending on individual
- After-care
- * Do not apply any makeup, chemical sunscreens, or active skincare for at least 24 hours post-treatment. Keep the area completely clean. * After 24 hours, apply a broad-spectrum physical sunscreen (SPF 50+) daily and avoid direct sun exposure for at least 2 to 4 weeks. * Avoid excessive heat (including hot showers, saunas, steam rooms, and intense exercise) for 48 hours. * Keep the skin hydrated using only a gentle, bland moisturizer and a mild cleanser recommended by your practitioner. * Avoid active ingredients (such as Retinols, AHAs, BHAs, Vitamin C, or exfoliating scrubs) for 5–7 days. * Do not pick, scratch, or scrub any micro-crusts or scabs that form; allow them to flake off naturally.
* This information has been provided by the clinic or owner of the device, not FABshaping.